Enterasys 6H308-48, Hardware Installation Manual

Page: 31 / 90

Installing Optional Network Expansion Module (NEM)
Matrix DFE-Gold Series PoE Module 4H4285-49 Installation Guide 3-3
Installing Optional Network Expansion Module (NEM)
A Phillips screwdriver is required to install an optional network expansion module into
the 4H4285 ‐ 49.
Refer to your release notes or the Enterasys Networks web site for the latest available
network expansion modules.
Installing an network expansion module involves
• removing the safety cover,
• removing the coverplate from the 4H4285 ‐ 49,
• attaching the NEM, and
• replacing the safety cover.
Specific installation instructions are shipped with each NEM.
DFE Module Placement and Installation Rules
The DFE module can be installed in a Matrix E7 (refer to Figure 3 ‐ 1 on page 3 ‐ 4 for
placement rules), Matrix N3, Matrix N5, or Matrix N7 chassis.
The Matrix N3, Matrix N5, or Matrix N7 chassis support only DFE modules and there are
no particular rules for installing modules.
Note: Install any optional equipment before proceeding to “DFE Module Placement and
Installation Rules” on page 3-3 for an explanation of the rules to install different series
modules in a Matrix E7 chassis.
Caution: Regardless of which chassis is used, the chassis system must be dedicated to
DFE-Gold modules (4xxxxx) only. Do not insert 7xxxxx modules or other legacy modules
into the same chassis with 4xxxxx modules as this will render the chassis inoperable.
Precaución: Cualquiera que sea el chasis que utilice, recuerde que el sistema debe
aplicarse exclusivamente a los módulos DFE (Distributed Forwarding Engine) de la serie
Gold (4xxxxx). No inserte módulos 7xxxxx ni otros módulos legado dentro de un chasis
con módulos 4xxxxx. Si lo hace, el chasis no funcionará.