ENSOTECH SWAVE-E2, User Manual

Page: 12 / 24

12
ESC Led Indication
Red On: Critical error (voltage / temperature / hardware fail) Contact Ensotech for RMA request
Motor / Phase error Line up A/B/C phsaes on both end
Throttle signal error Check Receiver and receiver cable
Firmware error Re-do Firmware update
Red Blinks: Cut off Protection Active
Hall sensor connected but signal not correct
Use Swave sensor cable
Red Off: Other cases
Blue On: Boost or turbo settings is not zero value Normal
Blue Blinks: boost and turbo settings is zero value Blinky Mode
Blue Off: Firmware error Re-do Firmware update
-Prevent the car runaway, do not connect the battery or switch on the ESC without switching on the transmitter.
Safety and General Information
- Unsuitable for children under 16 years old.
- Always remove the battery if the model is involved in any crash. Carefully inspect the circuit and soldering point.
- SERVO TESTER isn't appropriate for testing and operating complicated electronic devices.
- Swave ESC is a high-end racing product that offers many customised parameters.
Please consult your dealer or contact us if unsure about the setting.
- Do not overload the ESC due to incorrect/high gear ratios.
- Do not allow the motor, ESC and battery in contact with water or other fluids; or where is high humidity.
- When not in use, disconnect and remove the battery.
- If you have a bluetooth connection problem, always try to use another phone to test.
- Allow adequate space for proper ventilation.
Registered Trademark
ENSOTECH is a registered trademark of Ensotech Limited.
Other brands mentioned in this manual protect the property of their respective owners by copyright.
RMA Requests
Please download and fill out the RMA form http://www.ensotech.ltd/download/Ensotech_RMA_request_form.pdf and send
it to us with the item and invoice to prove the warranty.
For full details of warranty terms and conditions, please refer to our warranty page
https://shop.ensotech.ltd/
Ensotech Limited
Address: Unit F, 6
th Floor, Cheung Hing Shing Centre, No.23 Sha Tsui Road, Tsuen Wan, Hong Kong
Tel.: +852-3421 1446
Waste Disposal:
Broken or unusable are hazardous waste and must be disposed of in accordance.
Used ESC and Motor must not dispose of household waste. Customers are obliged to dispose to appropriate collecting points.
This manual is published by Ensotech Limited. It reflects the current technical specification at the time of print.
We reserve the right to change the technical or physical specifications without notice.