ENSONIQ MR Rack, Musician'S Manual

Page: 60 / 314

Chapter 3 —Personalizing Your System
To access the Parameters described on this page (unless otherwise noted):
Press the System button , turn the Parameter knob to locate the parameter ,
and then turn the Value knob to change the parameter's setting .
ENSONIQ MR-Rack Musician’s Manual 19
capacity o f 361 Sound laye r s — and can hold the same numbe r o f Sounds ( up to 128 )
and Pe r f o r mances ( 32 ) .
S R A M Ca r ds can be pu r chased inexpensively f r om compute r supply sto r es o r f r om
ENSON I Q, whose M C-512 S R A M Ca r d o ff e r s 4 Sound/Pe r f o r mance banks.
Fo r mo r e in f o r mation, see “ Using PC M C I A Data Ca r ds ” in C h a p t er 7 .
Note:
T he M R - R ack will not accept Flash PC M C I A ca r ds, o r any special- f unction
PC M C I A ca r ds, such as modem ca r ds f o r po r table compute r s, etc.
To Learn How Many Banks are on the Currently Installed Card
1. I nse r t an M R - R ack f o r matted PC M C I A data ca r d into the Data Ca r d slot with its label
side up and its connection edge towa r d the M R - R ack.
T o lea r n how to f o r mat a PC M C I A S R A M ca r d, see
C
h a
p t er
7
.
T he display will momenta r ily show :
PCMCIA Card Inserted
Registering...
2. P r ess System.
3. T u r n the Pa r amete r knob until the display shows “ C R D Size : ”
T his r ead-only display shows the numbe r o f banks on the installed ca r d. I f no ca r d is
installed, the display will show “ No ca r d !” in place o f the bank numbe r .
Ide nt if ying Inst alle d Wave Expansion Boar ds
T he M R - R ack can accommodate up to th r ee ENSON I Q E X P Se r ies W ave Expansion Boa r ds.
W ave Expansion Boa r ds p r ovide new wave data f o r the M R - R ack, as well as new Sounds,
Pe r f o r mances and demos. Fo r a f ull desc r iption o f how to install and use ENSON I Q E X P
Se r ies W ave Expansion Boa r ds, see “ Using ENSON I Q E X P W ave Expansion Boa r ds ” in
C h a p t er 7 .
T he M R - R ack p r ovides th r ee displays which can identi f y any E X P W ave Expansion boa r ds
you have installed.
To Identify an Installed Expansion Board
1. P r ess the System button.
2. T u r n the Pa r amete r knob until the display shows :
System parameters:
WaveEXP1:xxxxxxxxxxx
i
Expansion Board name
W hen an Expansion Boa r d is installed, this r ead-only display will show the name o f the
Expansion Boa r d located in the f i r st slot.