15
Copyright Enphase Energy Inc. 2010
141-00010 Rev 01
To check COOL mode (do not operate the AC if outside temperature is
below 65oF):
1.
Press the mode control
and select
COOL
.
2.
Press the blue
-
button to lower the cool target temperature to
50oF. Allow the system five minutes to respond.
3.
Verify that cool air is blowing from the system.
4.
Return the mode control
to
OFF
.
Congratulations, you have successfully installed your unit. Please
continue to the next section to initialize the Environ.
IMPORTANT:
After you have labeled and connected your wires, and
followed the correct HVAC set-up, if these check procedures do not operate
your system call Technical Support for the thermostat at 1-888-200-8514,
8am-midnight Eastern time.
