12
Copyright Enphase Energy Inc. 2010
141-00010 Rev 01
Mount the Environ to Wall
1.
Hold the Environ against the wall with the wires coming over the top
above terminal block. The Environ will cover the hole in the wall.
2.
Position the Environ for best appearance.
3.
Attach the Environ to the wall with the screws provided.
4.
If you are mounting the Environ to sheet rock, or if you are using the
old mounting holes, use the plastic anchors provided.
5.
Mark first and drill a 3/16-in.(4.8mm) hole for the insert at each screw
location, then mount the Environ.
HVAC Set-up on Screen Menu
With all the wires connected (including the C wire), it is time to turn the AC
power back on. Do this at the breaker or HVAC system you used to switch it
off. The Environ will power-up in the control OFF mode. Your Environ is not
configured to operate your HVAC system yet. You must now use the menu
driven HVAC SET-UP function.
IMPORTANT
:
Make sure the Environ is powered up and
is in the OFF mode before set-up. To turn your
thermostat off, press the
Power
button
in the middle
of the control bar to the right of the display and press
OFF
. Heating and cooling systems must be configured
separately.
Set-up for Normal Heating Systems (not heat pump)
1.
After all the wires are connected, follow the following steps:
2.
Remove the pull-tab for the battery located under the bottom
cover
