MAINBOARD BIOS SETUP
BIOS, Driver & Utility Guide
23
Assign IRQ For VGA
- The Enabled option allows the BIOS to auto-route an IRQ
for use by a VGA card. While most of the VGA cards do not need an IRQ
assignment, certain VGA cards may need it.
Assign IRQ For USB -
When Enabled, the system automatically assigns an IRQ
for the USB device connected to your system. However, if you are not using USB
devices and an ISA slot requires an IRQ address, set this function to Disabled. The
IRQ address previously occupied by the USB device will be available for the ISA
slot.
PCI Latency Timer -
This option sets latency of all PCI devices on the PCI bus.
The settings are in units equal to PCI clocks. Available settings are 0 ~ 248.
Load BIOS Defaults
Loads “Fail Safe” settings into the BIOS Setup program. These options are
designed to slow the system down for troubleshooting purposes. To load the default
values, highlight this option and press [ENTER]. Enter “Y” in the confirmation
screen and press [ENTER] again. User-defined options in the
Standard CMOS
Setup
are not affected.
Load Setup Defaults
Loads the default values for best system performance into the BIOS Setup program.
To load the default values, highlight this option and press [ENTER]. Enter “Y” in
the confirmation screen and press [ENTER] again. User-defined options in the
Standard CMOS Setup
are not affected.
