UM.02 ENOLINE WINE CARD
Page 6 of 46
Rev 08, May 2010
5. Unpack
When you removed the packaging, check that the Enomatic model has not been
damaged during transport. If you have any doubts, do not operate the
Enomatic model and quickly contact your Enomatic distributor in order to define
a supervising visit. Please make sure that following items are included in the
delivery:
-
1x - Enoline, 4 bottles capacity or 1x Enoline, 8 bottles capacity;
-
1x - Enoline Wine Card
Series 1 - User and Maintenance Manual;
-
5x - plastic straws or 10x plastic straws;
-
2x - steel holders to secure Enoline to the wall;
-
1x - Ø 10mm pipe for water drainage;
-
1x electrical cord;
-
1x spirit level;
-
1x - tap seals kit;
-
2x - fuses;
Never leave the packaging contents (plastic
bags, foamed polystyrene, nails, etc.) within
the reach of children, since they are a source
of potential danger. Please be eco- friendly and
recycle the packaging components. Above- mentioned operations
must be run by skilled personnel only and authorized by the
Manufacturer.
6 . Installation
For an optimum installation, a technical inspection is needed where the
installation will be performed, in order to establish the correct positioning,
ensure there is a suitable space for the location of the inert gas cylinder
(nitrogen or argon) and air compressor (if required) and an earthed electrical
socket which complies with the regulations.
1.
After unpacking your Enomatic Wine Serving System, place it on a solid desk
or holder, between 800 and 1300mm from floor. The surface where the
dispenser will be placed must be made by fire-extinguisher materials.
2.
Please consider a 300mm clereance on fridge
compressor side and 50mm aback in order to ensure
proper exhaust air exchange.
3.
Check the stance and correct it if necessary acting
on proper adjusting foot/feet. Refer to delivered
spirit level for accurate placement.
4.
Secure the machine through supplied holders to the
wall if needed.
5.
Tight pressure regulator (6434) to nitrogen or argon
tank, using supplied seal (if previewed).
6.
Connect FOODGRADE LLDPE 4mm pipes in order to
bond machine and nitrogen source.
7.
Connect the electrical cord and turn the machine on.
8.
Open the nitrogen or argon tank and turn the outlets
levers on vertical position; the gas will then reach
the machine.
9.
From now on Your Enomatic wine Serving System is ready for bottles
engagements. Enjoy your wines!!!!
