SETTING UP YOUR EBIKE 5
Miller SE EBIKE USER MANUAL
B. REMOVE TIES & PADDING
Using a 6mm allen wrench, undo the four bolts at the
top of the head stem and remove the top piece.
Place the knurled center section of the bar into the
mounting point of the head stem.
C. INSTALL HANDLEBAR
Replace the previously removed top piece and install
the four bolts by hand to ensure correct installation.
Slightly tighten each bolt at opposite ends (e.g. 1, then
4, then 2, then 3) a little at a time to ensure even pres-
sure is applied across the top piece.
Just before the bolts are fully tightened, adjust the han-
dlebar so that they are within comfortable reach when
riding the bike.
NOTE: This can be further adjusted after you’ve ridden
the fully assembled bike for comfort.
Tighten the four bolts to ensure a secure connection of
the handlebar to the head stem.
Using scissors, carefully cut and remove zip ties and
padding, ensuring you do not mark or damage the bike
or its components.
USE OF SCISSORS OR BLADES RISK
SCRATCHING OR HARMING YOUR
EBIKE. TAKE EXTREME CARE.
BE CAREFUL NOT TO OVER TIGHTEN
AS EXCESSIVE FORCE MAY DAMAGE
THE HEAD STEM THREADS.
4
3
1
2
