SETTING UP YOUR EBIKE 11
Miller SE EBIKE USER MANUAL
Once the charger jack is securely inserted into the
charging port, turn the charger on at the power point to
begin charging.
The indicator light on your battery charger will illuminate
red while it is charging, and then change to green once
the battery is full.
As you use the battery, periodically try to use the bat-
tery until it is completely empty and then charge it until
it is completely full before using it again. Fully cycling
the battery like this should help extend the life of the
battery. Batteries are ideally stored at 40%-50% charge
to maximize battery life.
1
Your Miller SE ebike comes eq uipped with a Gates car-
bon belt drive system. It is important to maintain belt
tension to ensure optimum energy is being transferred
from the crank to the rear wheel.
Your rear wheel axles are secured into the black drop-
outs via an 18mm nut. The belt tension and wheel align-
ment are set by adjusting the floating black dropouts
either forward or rearward as required.
To correctly adjust the drive tension, first locate and
loosen (anti-clockwise) both bolts (1) and (2) on each
side of the bike with an allen wrench.
7. DRIVE SYSTEM
ONLY ATTEMPT TO ADJUST YOUR
DRIVE SYSTEM IF YOU ARE EXPERI-
ENCED WITH CYCLE MAINTENANCE.
OTHERWISE, PLEASE CONSULT A
QUALIFIED BICYCLE MECHANIC.
1
2
Next, locate the setting screw via the hole at the rear of
the silver dropout arm, just above the main axle nut.
Using an allen wrench, turn in a clockwise direction to
move the black axle dropout rearward, and anti-clock-
wise to allow it to move forward.
Understand that adjusting just one side will affect wheel
alignment.
Be sure to adjust both left and right sides by the same
amount to maintain wheel alignment as you optimize
belt tension.
Once you have achieved the desired amount of tension,
tighten both the bolts (1) and (2) on both left and right
dropout securely.
For accurate belt tensioning it is recommended to
download the latest Gates Carbon Drive tuning app
from the iTunes or Google Play store and follow the
step by step in-app instructions.
When setting up your Miller SE ebike for the first time,
we recommend that you charge the battery to full over-
night. This allows the battery to balance.
To charge your ebike, locate the rubber charging port
towards the top of the downtube and open the cover to
reveal the charging port.
NOTE: Only use the included charger to charge your
battery.
With the battery charger switched off, insert the DC
barrel jack into the charging port on the bike.
8. BATTERY
ONLY OPERATE YOUR BATTERY AND
CHARGER BETWEEN 50 DEGREES
FAHRENHEIT (10C) AND 80 DEGREES
FAHRENHEIT (27C) TO AVOID COM-
PONENT FAILURE AND MINIMIZE THE
RISK OF INJURY.
IF YOU NOTICE SOMETHING UNUSU-
AL DURING THE CHARGING PROCESS,
TURN THE POWER OFF IMMEDIATELY
AND CONTACT US FOR ASSISTANCE
TO AVOID POSSIBLE INJURIES.
