SETTING UP YOUR EBIKE 9
Miller SE EBIKE USER MANUAL
Ensure the motor cable is securely connected to the
controller connector cable.
If disconnected, simply line up the arrow on the mo-
tor cable with that on the connector cable, and press
together carefully. Notice that one side has a ‘female’
connection with holes and other a ‘male’ connection
with pins. The connection is made such that the pins fit
exactly into the holes on the other side.
4. REAR HUB MOTOR
If there is resistance do not force the two together, as
this may bend pins out of place and destroy your con-
nection. Simply put apart gently, then try again by align-
ing the arrow guides together and pushing carefully.
Your Miller SE ebike comes equipped with front and
rear hydraulic disc brakes, designed to help you slow
down and stop as required.
It is therefore recommended to service your brakes reg-
ularly to ensure:
i. the brake pads are in suitable usable condition
ii. the brakes are adjusted correctly so that calipers and
pads make appropriate contact with the brake rotor
iii: lever pulls translate to sufficient braking power
iv: hyraulic brake fluid is in suitable condition for brake
use.
Front brake caliper positioning adjustments and remov-
al can be accessed via bolts (1) and (2) above with an
allen wrench.
5. BRAKES
Rear brake caliper positioning adjustments and removal
can be accessed via bolts (1) and (2) above with an al-
len wrench.
DO NOT RIDE THE EBIKE WITH-
OUT THE MOTOR CABLES PROPER-
LY CONNECTED. DOING SO COULD
DAMAGE COMPONENTS AND RESULT
IN SERIOUS INJURY.
KEEP IN MIND THAT WHILE YOUR
BIKE’S BRAKES ARE STRONG, WE
HOLD NO RESPONSIBILITY
IN THE EVENT OF FAILURE.
1
2
1
2
