9
i
mportant
s
aFety
p
reCautions
D
a
V
inCi
s
etup
1. Unpacking and transporting the DaVinci.
During unpacking and transporting, be sure to lift
the DaVinci by the built-in carrying handle. Do not
attempt to lift or carry the LCD by the base or the
camera arm. (See Figure 1)
2. Setup the DaVinci. Place the DaVinci on a flat,
level surface such as a table or desk.
3. Connect the AC power. Connect the attached
power cord to the power supply. (See Figure 2)
Connect the power cord to an available electrical
outlet. (See Figure 3) To offer additional protection
during an electrical storm, a surge protector may
also be used and is recommended. Connect the
other end of the power supply to the DaVinci
where it is labeled “+19VDC”
The DaVinci will automatically power on
the first time it is connected to an available
electrical outlet.
Pressing the Power button on the front, right side,
of the DaVinci (See Figure 4) for less than 5
seconds will put the device in Standby. Pressing
the Power button again will wake the DaVinci up
from Standby.
To turn the DaVinci off, press and hold the
Power Button for more than 5 seconds or until “EV
DaVinci” appears on the screen.
Figure 1
Figure 2
Figure 3
DAVINCI SETUP
Figure 4
