Spider® AT
User's Guide
P a g e 20
Revision: Draft
3.2.2
CONFIGURE THE SPIDER ASSET TAG TO USE THE PROVISIONER
In order to use the Enfora Provisioner to configure the Spider Asset Tag, you will
first need to send communication parameter information to the device with a
terminal emulator:
Any terminal emulator program such as ProComm or HyperTerminal can be used
to send AT commands to the device. Configure the terminal emulator with the
following settings:
Baud rate is fixed at 115200
No Parity
8 bits
1 stop bit
Step-by-step illustrated instructions for setting up HyperTerminal can be found in
Section 0 (Appendix C) of this User’s Guide.
Below are the basic commands required to establish communication between a
device and the Gateway/Provisioner server.
AT Command
Command Description
AT$MDMID="[MDMID]"
Choose a unique identifier for your modem
ID
AT+CGDCONT=1,"IP","[APN]"
Configure Carrier APN, where [APN] =
APN specific to the SIM used
AT$UDPAPI=,[PORT]
Configure Server Port, where [PORT] =
Port that the Gateway server is monitoring
for Modem messages
AT$FRIEND=1,1,"[SERVER]",[PORT],3
Configure Server, where [SERVER] = URL
or IP address of the server to report to.
[PORT] is the TCP port that the device will
use for FTP.
AT$APIOPT=1,1,0
Configure To use Extended API header
and Send the Modem ID and the Param2
values with every report.
AT$AREG=2
Auto Registration Mode Set modem to
automatically attempt a PDP activation on
power-up.
AT&W
Save these settings on the device.
