LCD METER
USER MANUEL
3
This illustrated manual will help you understand how the meter works, how to operate the meter,
how to change the settings and how to improve the performance of the electric motor.
FUNCTIONS AND DISPLAY
OPERATION
1. On/Off
Hold the button
(SW)
to turn the meter on or off. The meter will automatically shut down when the vehicle has been stopped and the buttons haven’t been
pressed for five minutes.
The power supply of the electric vehicle will also be turned off.
In power off mode, the meter and controller don’t consume any power.
2. Display 1 :
1
Up button
10
6 km/h power assistant push
2
Start/stop button (SW)
11
KM/H
Riding speed (metric)
3
Down button
MPH
Riding speed (imperial)
4
Battery capacity indicator
MXS
Max speed
5
Backlighting and lights
AVS
Average speed
6
Brake display
12
KM
Distance (metric)
7
TM
Single trip time
MIL
Distance (imperial)
TTM
Total trip time
DST
Trip distance
8
Motor W
Power display
ODO
Total distance
Motor ºC Motor temperature
VOL
Battery voltage
Motor ºF
Motor temperature
13
ASSIST Pas level
9
ºC
External temperature
CRUISE Cruise function
ºF
External temperature
Hold the button
(SW)
shortly to start up the meter and enter display 1.
2.1 Turn on the backlighting and lights
Hold the button
(UP)
and the meter will turn on the vehicle’s back and front lights. The light logo will appear.
Hold the button
(UP)
again to turn off the lights.
2.2 Assist gear ratio (assist switch)
Hold the button
(UP)
or the button
(DOWN)
to switch the power assist ratio (or throttle switch) gear.
This will change the motor output power. The gears can be switched between 1 and 5
(this can also be configured according to your requirements). Gear 1 = lowest power. Gear 5 = highest power.
2.3. 6 km/h power assist function
When you hold the button
(DOWN)
, the meter assist function logo
( )
will flash, and the vehicle will drive at 6 km/h max.
Release the button
(DOWN)
and the assist function will be disabled.
2.4. Cruise Function
Hold the button
(DOWN)
to enter cruise mode. When the vehicle’s speed is higher than 7 km/h, the cruise function logo
(CRUISE) will light up. Brake or hold any button to disable the cruise function.
2.5 Single Data Clearing
5 seconds after the meter is turned on, hold both the button
(UP)
and the button
(DOWN)
simultaneously for about
2 seconds. When the single trip time (TM) and the single trip distance (DST) flicker, hold the button shortly
(SW)
, and the
content will be cleared. If you don’t hold the button for 5 seconds, the original content will be saved.
