3
MODEL: EWC12-1.5
USER’S MANUAL
6. FOLLOW THESE STEPS WHEN BATTERY IS INSTALLED
IN VEHICLE.
A SPARK NEAR BATTERY MAY CAUSE BATTERY EXPLOSION.
TO REDUCE RISK OF A SPARK NEAR BATTERY:
(CONTINUED)
6.8 Connect charger AC supply cord to electrical outlet
6.9 When disconnecting charger, turn switches (if supplied) to off, disconnect charger from AC power, remove clip from vehicle
chassis, and then remove clip from battery terminal. See operating instructions for length of charge information.
7. FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE.
A SPARK NEAR THE BATTERY MAY CAUSE BATTERY EXPLOSION.
TO REDUCE RISK OF A SPARK NEAR BATTERY:
7.1 Check polarity of battery posts. POSITIVE (POS., P, +) battery post usually has a larger diameter than NEGATIVE (NEG., N, -) post.
Some batteries are equipped with 'Wing-Nut' terminals allowing for easy placement of the terminals to these posts.
7.2 Attach at least a 24-inch long 6-gauge (AWG) insulated battery cable to NEGATIVE (NEG., N, -) battery post.
7.3 Connect POSITIVE (RED) charger terminal to POSITIVE (POS., P, +) post of battery.
7.4 Position yourself and free end of cable as far away from battery as possible - then connect NEGATIVE (BLACK) terminal
to free end of cable.
7.5 Do not face battery when making final connection.
7.6 Connect charger AC supply cord to electrical outlet
7.7 When disconnecting charger, always do so in reverse sequence of connecting procedure and break first connection
while as far away from battery as practical
7.8 This on board battery charger is also suitable for charging a marine (boat) battery, it is also designed for marine use.
8. OPERATING INSTRUCTIONS
8.1 Once the connection instructions have been followed, Plug-in AC power, The charge will turn to charging automatically,
While the “Charging” Green (LED) will flash when on charging. The “Maintaining” Green (LED) will ON when end of charging.
Float Mode allows the charger to effectively be left connected to your batteries, over the course of a season, without
overcharging your batteries and maintains your battery's full charge.
9. SPECIFICATIONS
9.1 Input voltage: 120Vac 50/60Hz 0.4A Max.
9.2 Charging starting conditions: Battery not less than 5.5V
9.3 Rating output: 12Vdc 1.5A
9.4 Battery type: Lead-acid battery
9.5 Maximum charging voltage: 14.4V
9.6 Maintenance charging voltage: 13.1V~13.5V
9.7 Operating Environmental:-10~40 °C, 90% RH Maximum
9.8 Weight: 0.28kg approx.
9.9 Dimensions: L119 x W73 x H32mm
10. REVERSE BATTERY / OUTPUT PROTECT CONDITION.
The charger has reverse battery and output short circuit protection. If polarity is reversed (“FAULT” Red LED is on), simply unplug
charger from AC power and properly remake the connections as described in this manual.
