4
MODEL: EWC12-1.5
USER’S MANUAL
Distribué par
|
Distributed by:
Trans-Canada
Energies
700, chemin du Grand Bernier Nord
Saint-Jean-sur-Richelieu
(Québec) J2W 2H1
Phone/Téléphone: 450 348-8720
Toll free/Sans frais: 1 800-661-3330
FABRIQUÉ EN CHINE - MADE IN CHINA
11. INSTALLATION
1.0 THE BATTERY CHARGER IS MOUNTED DIRECTLY
to the fender well of your vehicle as shown in figure -1. If using the nuts and bolts provided, drill two 1/8’’ holes in diameter.
If the backside of the mounting surface is hard to reach, you may consider using two 1/2’’ long sheet-metal screws (not supplied)
instead of the nuts and bolts provided.
2.0 MOUNTING THE CHARGER ALONG SIDE THE BATTERY:
If more convenient to do so, as the following figure-2, using the
mounting bracket (supplied) to mount the battery charger along
side of the battery. If possible, mount the charger to the side of the
battery away from the engine and fan blades. Mount the bracket
to the charger as shown, using the nuts and bolts provided. Loosen the bat-
tery retaining hardware enough that you can insert the bracket between the
bottom of the battery and the battery mounting tray as shown. Position the
charger so that it will not rub against the battery or any other part of the ve-
hicle, and then tighten the battery retaining hardware.
CAUTION: Do not drill or puncture the battery.
Electrical Installation –
The output leads of the charger are terminated ring lugs. Route and secure the AC cord and the output
wiring away from the gas line, carburetor or other hot, sharp or moving and pinch parts to avoid damage to the insulation. Secure
the AC cord using a cable tie or equivalent.
12. MAINTENANCE
Store in a clean and dry place; occasionally clean the case and cords with a dry cloth.
Figure 1
Figure 2
Figure 3 - battery with studs
