enervent eWind Pinion, Installation Instructions Manual

Page: 98 / 124

98
Measurement display
You can monitor temperature, humidity, heat recovery
efficiency and other measurement values from the eWind
measurement list, displayed on the operating panel.
eWind measurement list
Marking Definition
Marking in the
diagram and
connection on
the automation
motherboard
Note
Modbus
register
r1 Outdoor air temperature, °C TE01 All models 6
r2 Supply air temperature after heat
recovery, °C
TE05 All models 7
r3 Supply air temperature, °C TE10 All models 8
r4 Extract air temperature, °C TE30 All models 10
r5 Exhaust air temperature, °C TE32 All models 9
r6 Return water temperature of water-
based heating coil, °C
TE45 eWind W only. Other models
display ‘0’.
12
r7 Temperature of pre-heated outside
air (CHG/AGH/electric preheat coil),
°C
TE02 Only if equipped with CHG/
AGH or electric preheat coil.
32
r8 Relative humidity (RH) of extract air RH30 All models 13
r9 Carbon monoxide level, ppm Without an external carbon
dioxide sensor (accessory), ‘- -’
is displayed
23
r10 Measurement of external relative
humidity, %RH
Without an external humidity
sensor (accessory), ‘- -’ is
displayed
23
r11 Temperature efficiency of the supply
air heat recovery, %
All models
Calculated value
29
r12 Temperature efficiency of the extract
air heat recovery, %
All models
Calculated value
30
Commissioning documentation
•
Fill in the warranty information.
•
Mark the changes you have made to the factory
settings in the column
Field setting
in the table
‘Parameter list’ on page 16.
•
Fill in the airflow measurement document.
1
Simultaneously press buttons and two
times.
• Parameter (r1..rn) and the parameter values are displayed.
2 Browse the parameter list up or down, by pressing
button
or .
eWind measurement list
Opening:
1
Simultaneously press buttons and once.
Return to the standard view:
The warranty is not valid for units with no
documented airflowmeasurement.
It is extremely important to note all changes
made to the parameters. This ensures that there
are backup copies of the information in case
the automation is damaged (for example, by a
lightning strike).
FOR YOUR INFORMATION