enervent eWind Pinion, Installation Instructions Manual

Page: 94 / 124

94
3
5
4
1
2
6
The control system and the eWind operation panel
1. Mode (in standard
display)
2. Temperature (in standard
display)
3. Mode button
4. Eco button 5. Temperature button 6. Cable connection
Important information
on the control system
The factory settings are suitable for most installations.
The fan speed settings for various operating modes
are installation specific and must be specified and set
individually in each installation. For the rest of the settings,
the factory setting must not be changed unless otherwise
instructed in the ventilation system plan.
Make sure that all necessary information is available before
starting to adjust the settings.
Setting the
operational parameters
The fan speed settings for various operation modes must
be specified and set individually in each installation. Refer
to the settings in the parameter list.
1
Simultaneously press buttons and three
times.
2
Using buttons and , choose parameters
c31-c32.
• Refer to the meaning of each parameter in ‘Parameter list’ on
page 16.
3
Choose the parameter for adjustment by pressing
button
for 3 seconds.
4
Change the parameter value using buttons
and .
5
Confirm the value and return to the selection of
parameters c1–c32 by pressing button
.
6
Exit the settings by simultaneously pressing
buttons
and .