enervent eWind Pinion, Installation Instructions Manual

Page: 96 / 124

96
Parameter list
Parameter
Description
Factory
setting
Note
Modbus
register
Field
setting
c23 Humidity boosting
on or off
On Coil 19
c24 Threshold value of summer/winter
temperature, for humidity boosting
control range –10…+10 °C, step 1 °C
4 °C
The 24-hour average temperature of the
outdoor air. Above the threshold value the
humidity boosting is in summer mode, and
below the threshold value it is in winter
mode.
137
c25 Threshold value for humidity boosting,
control range 10…100 %RH, step 5 % 45 %
In winter mode, the himidity boosting is
started when the humidity value exceeds
the threshold value.
69
c26 Threshold value for humidity boosting,
control range: 5…30 %, humidity exceeds
the 48-hour average value, step 5 %
15 %
In summer mode, the humidity boosting is
started when the relative humidity exceeds
the 48-hour average value of humidity by
the amount of the threshold value.
70
c27 Carbon dioxide boosting
on or off
Off Coil 21
c28 Threshold value for carbon dioxide boosting,
control range: 600...1,200 ppm, step: 100
ppm
1,000
ppm
76
c29 Mode for increased humidity removal using
the rotating heat exchanger
on or off
Off Coil 24
c30 Display dimmed in standby mode
on or off
Off
Panel-specific setting off: display is dark in
standby mode,
on: dimmed display in standby mode.
Internal
c31 Modbus address of the automation
motherboard
control range: 1...99, step: 1
1 640
c32 Modbus network speed
1 = 9,600, 2 = 19,200, 3 = 115,200
2 19 200 bps 733