enervent eWind Pegasos, Installation Instructions Manual

Page: 123 / 136

Name Definition
Marking on the circuit
board
FP/EX FIREPLACE/RANGE HOOD MODE DI6
AWAY AWAY MODE DI5
BOOST MANUAL BOOSTING DI4
ESTOP EMERGENCY STOP DI1
TE01 OUTDOOR AIR TEMPERATURE TE01
TE02 PRE-HEATED OUTDOOR AIR TEMPERATURE, EXTERNAL PRE-HEATER TE02
TE05 AIR TEMPERATURE AFTER THE HEAT RECOVERY HEAT EXCHANGER TE05
TE10 SUPPLY AIR TEMPERATURE TE10
TE32 EXHAUST AIR TEMPERATURE SENSOR TE32
TE45 RETURN WATER TEMPERATURE SENSOR eWind W MODELS TE45
TE46 RETURN WATER TEMPERATURE SENSOR eWind CG MODELS TE45
RH CO₂ EXTERNAL HUMIDITY SENSOR AS DEFAULT (RH 0–100%). IF PARAMETER c27 IS ACTIVE, CO₂ SENSOR
(200–2,000 ppm) (ACCESSORY)
AI1
TL01
TL50
PRE-HEATING ACTUATOR, CHG MODELS. COOLING ACTUATOR, CG MODELS AO6
TL45 HEATING ACTUATOR, W MODELS AO5
DO8 ALARM OUTPUT A AS DEFAULT PRE-HEATING ON/OFF CONTROL, CHG –AGH, ELECTRIC PRE-
HEATER MODELS COOLING ON/OFF CONTROL, CG MODELS, CONDENSATE TRAY HEATER
DO8
DO5 OUTDOOR AIR AND EXTRACT AIR DAMPER CONTROL (ACCESSORY) DO5
DO2 HEATING ON/OFF CONTROL eWind MODELS MAX 500-W PUMP DO2
OP1 CONTROL PANEL (1) INCLUDED IN THE DELIVERY, 10-M CABLE ALSO INCLUDED IF THE CONTROL
PANEL HAS NOT BEEN INSTALLED IN THE VENTILATION UNIT
OP1
OP2 CONTROL PANEL (ACCESSORY), 10-M CABLE INCLUDED IN THE DELIVERY OP2
RHT30 EXTRACT AIR TEMPERATURE AND HUMIDITY SENSOR(RH 0-100%) RHT30
SF10 SUPPLY AIR FAN AO1,DI11
EF30 EXTRACT AIR FAN AO2,DI12
M75 HEAT RECOVERY HEAT EXCHANGER MOTOR AO4
TZ+ OVERHEAT PROTECTION AUTOMATIC RESET
TZA OVERHEAT PROTECTION MANUAL RESET
TS02 CAPILLARY THERMOSTAT