enervent eWind Pegasos, Installation Instructions Manual

Page: 103 / 136

103
Installation instructions for professionals
3
5
4
1
2
6
Control system and the eWind operation panel
1. Mode (standard display) 2. Temperature (standard display) 3. Mode button
4. Eco button 5. Temperature button 6. Cable connection
Important information about the control
system
The factory settings are suitable for most installations.
The fan speed settings for various operating modes are
installation specific, and they must be specified and set
separately in connection with each installation. In other
cases, the factory setting must not be changed unless
otherwise instructed in the ventilation system plan.
Make sure that all necessary information is available before
starting to adjust the settings.
Setting the operational parameters
The fan speed settings for different operation modes must
be specified and set separately in connection with each
installation. The settings are described in the parameter
table.
1
Simultaneously press buttons and three
times.
2
Using buttons and , choose the parameters
c1-c32.
• The meaning of each parameter is described in
section ‘Parameter list’ on page 16.
3
Select the parameter to be adjusted by pressing
button
for 3 seconds.
4
Change the parameter value using buttons
and .
5
Confirm the value and return to the selection of
parameters c1–c32 by pressing button
.
6
Exit the settings by simultaneously pressing
buttons
and .