www.enersys.com Publication No. US-FL-IOM-002 January 2007 Page
17
7.
Place the loops on the two free ends of the belt over
the hook of the lifting device, and then place the middle
loop over the hook. See Figure 6.9.
LIFTING LARGE-SIZE CELL
Figure 6.9
Be sure the belt is not twisted. Straighten the belts down each
side and under the bottom of the cell/unit, so that they are
parallel with each other. The space between the belts should
be the same as the distance between the belt notches on the
edge of the styrofoam. Correct belt spacing is important
because it permits removal of the belt after the cell/unit has
been placed on the rack rails.
8.
Lift cell into position and remove belt.
Exercise extreme care when initially lifting cells and when
lowering them into final position on the rack. To prevent one
end of the unit from "kicking out," assign one person to steady
the unit on a level plane during the entire lifting procedure.
Summary of Contents for PowerSafe Data Safe
Page 8: ......
