Energie AQUAPURA SPLIT 160i, Technical Manual

Page: 57 / 108

57
AQUAPURA SPLIT
English
Technical Manual
5.2. Start-up of the System
Before starting the Split check whether the installation is set up according to the recommendations and
that everything is in conformity, then you may plug your equipment to the power supply.
After switching on your equipment you should wait a few seconds until the controller begins to work .
Then you may start your equipment following these instructions:
6. SYSTEM OPERATION
6.1. Control Panel
The control panel of the
Split
is simple and intuitive. It enables the configuration of several operating pa -
rameters according to the operating mode selected by the user.
1. Switch ON/OFF;
2. Operating indicator Led (green led - system is
ON / led off – system is OFF)
3. Navigate through menus, up and down;
4. Allows you to switch on and off the electrical
resistance;
5. Timer clock control;
6. Enter
1. Temperature Set point / Water temperature/
Error message;
2. Error alarm;
3. Electric Heater operation indicator;
4. Compressor operation indicator;
5. Timer (hh:mm);
6. Operation periods;