Energie AQUAPURA SPLIT 160i, Technical Manual

Page: 56 / 108

56
AQUAPURA SPLIT
English
Technical Manual
Connector Description
CT1 Transformer
CT2 Transformer
COMP Compressor
S1 Selector
SW1 Button
Controller Controller
Power supply Power supply
E-heater Electric Heater
N Neutral
F Phase
COM1 Display Connection
PRO_P High pressure switch
T5L Cylinder temperature probe
T3 Evaporator temperature probe
T4 Ambient air temperature probe
Th Aspiration temperature probe
Tp Compressor discharge temperature sensor.
EEV Electronic expansion valve
Power 1 Display power
TRANS OUT Transformer output
TRANS IN Transformer input
4-Way 4 way valve
LOW SPEED Low speed fan
HIGH SPEED High speed fan
Compressor outsider overload protection Compressor outsider overload protection
Compressor capacitor Compressor capacitor
E-heater control board E-heater control board
The wire passes through the CT1, CT2 direction must be consistent, otherwise it will lead to failure.
5. FIRST USE
5.1. Filling the tank
a) Open hot water tap(s);
b) Open tap/cold water section valve next to safety device (this procedure also serves the purpose
of checking whether the discharge valve is shut off);
c) Once there is a flow from the hot water tap(s), shut it. Your storage water heater is now full;
d)Check the tightening in the pipes;
e) Carry out successive discharges through the safety valve to ensure the good running condition
of all hydraulic components in the installation;