4
This fixture is warranted to perform free from defects for five years. If it fails to do so, you may
return it with proof of purchase to 13445 12th St., Chino, CA 91710 for replacement.
Clean with a mild, non-abrasive glass cleaner and soft cloth. Do NOT use solvents or clean-
ers containing abrasive agents. When cleaning the fixture, make sure the power is turned
off, and any liquid spray should be applied to the cleaning cloth and not sprayed directly onto
the fixture itself.
www.energeticlighting.com
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
TROUBLESHOOTING
WARRANTY
Problem
Possible Solution
Corrective Action
Fixture does not light.
Circuit breaker trips
when light is turned on.
1. Power is off.
2. Incorrect wire connection.
3. Defective wall switch.
Crossed wires or power
wire is grounded out.
Verify wires are correctly
connected.
1. Check circuit breaker
or wall switch.
2. Check wire splices.
3. Replace switch.
2. Align the large opening of the 3 keyhole slots on the
reflector (B) with the 3 extended screws on the fixture
body (A), turn the reflector clockwise until the screw
heads sit over the narrow end of the keyhole slots.
Torque down the screws so that the reflector (B) is
secured to the fixture body (A).
Fig. 2
4. Hang the fixture onto a structural hook on the
building, ensure that the hardware is properly rated
for the fixture weight. Attach or loop the free end of
the safety cable (C) onto a structural beam or
mounting point.
Fig. 4
3. Attach one end of the safety cable (C) to a solid point
on the rear of the fixture body (A).
Fig. 3
6
Printed in China
www.energeticlighting.com
5. Route the input wires into an available junction box
securing the line with an appropriate junction box
fitting. Connect the wires black to black, white to
white, and green to green.
Dimming Connection:
If fixture is to be connected to
a dimming system, connect the purple and gray leads
to its corresponding 0-10v dimming supply leads.
Otherwise, leaving the fixture 0-10v dimming leads
open will enable the fixture to run at 100% lumen
output.
Fig. 5
A
B
B
Junction
Box
C
