background image

This equipment has been tested and found to comply with the limits for a Class B digital 

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential installation. This 

equipment generates, uses and can radiate radio frequency energy and, if not installed and 

used in accordance with the instructions, may cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off and on. The 

user is encouraged to try to correct the interference by one or more of the following 

measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected.

Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003.

3

2

-

-

-

-

Please read and understand this entire manual before attempting to assemble, operate or 

install the product. Failure to do so could lead to electric shock, fire or other injuries that 

could be hazardous or even fatal.

Be sure the electricity to the wires you are working on is shut off. Either remove the fuse or 

turn off the circuit breaker.

Changes or modifications not expressly approved by the party responsible for compliance 

could void the user’s authority to operate the equipment.

This product must be installed in accordance with local, state and national electrical codes.

Installation work shall be completed by a licensed installer that is familiar with the 

construction and operations of the product.

CAUTION:  

The fixture body is one piece.  Do not disassemble it.

This product can only be dimmed when connected to a 0-10v dimming system.

NOTICE

This device complies with Part 15 of the FCC Rules. Operation is subject to the following 

two conditions: (1) This device may not cause harmful interference, and (2) this device 

must accept any interference received, including interference that may cause undesired 

operation.

Before beginning assembly of product, make sure all parts are present. Compare parts with 

package contents list and hardware contents list. If any part is missing or damaged, do not 

attempt to assemble the product.

Estimated Assembly Time:

 20 minutes.

Tools Required for Assembly (not included): Phillips screwdriver, flathead screwdriver, safety 

glasses.

Before begining installation, ensure that power is disconnected to the supply wires.

1. Back out the 3 screws at the front of the fixture body 

(A) leaving about 1/4-inch between the screw head 

and the fixture body.

www.energeticlighting.com

www.energeticlighting.com

Part

Item Name

Qty.

A

Fixture Body

1

B

Reflector (packaged separately)

1

C

Safety Cable

1

PACKAGE CONTENTS

SAFETY INFORMATION

SAFETY INFORMATION

PREPARATION

INSTALLATION INSTRUCTIONS

Fig. 1

B

A

Back out 3 screws

leaving 1/4” of exposed

thread

A

C

Reviews: