24V COMBI DRILL ENF464COM
10. MAGNETIC STRIP
The backup bit can be placed
on the magnet
temporary
during working. Just put the bit on it. (Fig.8)
11. BATTERY LEVEL INDICATOR
If press the button (11),
battery power is displayed on the
screen.
When the three lights are on, the battery is operating at
capacity. When two lights are on, it shows that the battery
capacity begins to decrease. When only one light is lit, it
indicates the need to recharge the battery (Fig.9).
12. DRILLING
When drilling hard smooth surfaces, use a center punch to
mark the desired hole location. This will prevent the drill bit
from slipping off center as the hole is started. Hold the tool
firmly and place the tip of the bit at the point to be drilled.
Depress the switch trigger to start the tool. Move the drill bit
into the work-piece, applying only enough pressure to keep
the bit drilling. Do not force or apply side pressure to
elongate a hole.
Warning:
Tungsten carbide drill bits should always be used for
concrete and masonry. When drilling in metal, only use
HSS drill bits in good condition. Always use a magnetic
bit holder when using short screwdriver bits. When
screw-driving, apply a small quantity of liquid soap or
similar to the screw threads to ease insertion.
13. DISPOSAL OF AN EXHAUSTED BATTERY PACK
To preserve natural resources, please recycle or dispose of
the battery pack properly. This battery pack contains
nickel-cadmium batteries. Consult your local waste authority
for information regarding available recycling and/or disposal
options. Discharge your battery pack by operating your drill,
then remove the battery pack from the drill housing and
cover the battery pack connections with heavy duty
adhesive tape to prevent short circuit and energy discharge.
Do not attempt to open or remove any of the components.
Fig.8
Fig.9