![background image](http://html.mh-extra.com/html/energer/enf464com/enf464com_safety-and-operating-manual_2409714014.webp)
24V COMBI DRILL ENF464COM
Operating instructions
Fig.1
Fig.2
Fig.3
1. INSTALLING AND REMOVING BITS
Warning!
Always remove the battery before you change the drill or
screw bit to avoid unintentional starting of the machine.
1. Open the drill chuck by holding the rear section of the
chuck and turn the front section in an anti-clockwise
direction, until the jaws are open enough. (Fig.1)
2. Insert the bit firmly into the chuck. To tighten, turn the
front section of the chuck (while holding the rear section) in
a clockwise direction until the bit is fully installed and
maintained. (Fig.2)
3. To remove the bit, just open the chuck and then remove it
by hand.
2. USE A BIT HOLDER FOR SCREWDRIVER BITS
Insert the magnetic bit holder in the chuck according to
above steps and place the bit into the holder which been
selected.(Fig.3)
To remove the bits, just pull out the bit by hand.
3. THE AUXILIARY HANDLE
Drag the handle on the tool head.
Turn the handle lock knob to lock and tighten securely.
Depending on the working method, the auxiliary handle can
be adjusted in different positions.
CAUTION!
Do not continue to use an auxiliary handle if it is damaged.
4. ON/OFF SWITCH WITH BRAKE FUNCTION
Depress the On/Off switch to start and release it to stop your
drill. The on/off switch is fitted with a brake function which
stops your chuck immediately when you quickly release the
switch.
5. VARIABLE SPEED
This tool has a variable speed switch that delivers higher
speed and higher torque with increased trigger pressure.
Speed is controlled by the amount of switch trigger
depression.
Warning!
Do not operate for long periods at low speed because
excess heat will be produced internally.