Care and maintenance
Adjusting the blade guide
1) Upper support bearing (Fig. 28)
> Undo the hex screw (47) with 3mm hex key supplied.
> Move the support bearing (42) so that it is almost touching the blade (23). There
should be a gap of approx. 0.5mm.
> Re-tighten the hex screws (47).
2) Adjusting the lower support bearing (29)
> Adjust in the same way the upper support bearing adjusted.
> Whenever you change the blade you must reset both the support bearings
(42+43) and the guide pins (44 + 45). (Fig. 28 & 29)
> Undo the fixing knobs (2) to open the left side cover (3). (Fig. 30)
> Undo the hex screws (46) and remove the blade guard (6). (Fig. 31)
29
ENB542BDS
by ENERGER
In
more
detail…
GB
IE
Fig. 30
Fig. 31
Fig. 29
Fig. 28
3
350W BAND SAW
2
6
46
51
42
44
49
50
53
47
48
45
43
52
23
23
