Adjusting the work table to 90°
> Move the upper blade guide to the top.
> Undo the fixing handle (18). (Fig. 17)
> Set the angle between the blade and the table.
> Tilt the work table until it is at an angle of exactly 90° to the blade.
> Re-tighten the fixing handle.
> Undo the nut (35) with 10mm spanner (not supplied). (Fig. 18)
> Adjust the hex screw (36) until it contact with the machine frame.
> Re-tighten the nut (35). Then fasten the hex screw (36) with 3mm hex key (37).
(Fig. 19)
> Undo the recessed head screw locked on the scale pointer (17) to position the
angle scale pointer (17) on the 0° mark on the dial scale (19). (Fig. 17)
> Re-tighten the setting wheel.
> Re-tighten the fixing handle.
> Check the setting before each cut and re-adjust if necessary.
Before you start
Getting
started...
GB
IE
ENB542BDS
by ENERGER
20
Fig. 17
Fig. 18
Fig. 19
Fig. 16
counterclockwise
12
7
clockwise
18
19
17
35
37
35
36
36
