Enerdrive MagnaSine Smart Battery Combiner ME-SBC, Owner'S Manual

Page: 7 / 20

©2010 Enerdrive Pty Ltd 4
Installation
2.4 Configurations
The ME-SBC
TM
can be configured to accomplish battery combining in a simple, flex-
ible way. There are two methods and they are as follows:
25 Amp Combiner - This configuration is simple to install and use. The 3-wire con-
nection system is similar to connection methods used by other battery combining
products. One of the the advantages of this controller is the advanced combining
options that are available to the installer. It is best to choose this method when
designing systems where 25 amps or less are required. For this configuration see
Figure 2-5.
Solenoid Drive - If more battery combining capacity (or Ampacity) is required the
installer can employ any solenoid, so long as the coil of that solenoid consumes less
than 2 Amps. The source that provides power to the solenoid must not exceed 40
VDC. This circuit switches DC Negative to the accessory terminal block position #4
entitled Solenoid (-). For this configuration please see Figure 2-6.
Figure 2-2, Power Terminal Block
Figure 2-3, Accessories Terminal Block
2.3 Connections
Please refer to the diagrams below for connectivity information.