14
©2010 Enerdrive Pty Ltd
Operation
04 BM: Status - This menu selection displays “read-only” displays that give the
current operating status of the Battery Monitor (BM). This selection also provides
information to know if there is a power-up fault condition.
Figure 5-3, METER: 04 BM: Status Display
• BM: Pwr-up Fault - The BM faulted when it was powered-up; the fault
occurred because the power-up self-test failed. See the Troubleshooting section.
• BM: No Comm - The BM is not communicating with the remote. This typically
means a ME-BMK is not installed in the system. If installed, view the Sense
Module LED and use Table 5-1 to help determine the issue.
• BM: Ready - The BM is connected and actively monitoring the battery
system.
05 BM: SETUP - This menu allows the battery’s charging efficiency to be automati-
cally determined or manually selected; normally the charging efficiency is automati-
cally calculated (default setting is “Auto”). If you know your battery’s efficiency and
want information on changing this setting from the “Auto” selection, return to the
SETUP section.
06 BM: TECH - These menu selections allow you to access system information
used to assist service technicians in troubleshooting the Battery Monitor or the
charging system..
Figure 5-4, METER: 06 BM: TECH Selections
• BM Rev - This “read-only” menu displays the firmware revision level of
the connected Battery Monitor. If the Battery Monitor is not connected or not
communicating, the display will show “0.0”.
