5. FAULT INDICATOR
When a fault occurs, LED2(100%)/LED3(75%)/LED4(50%)will blink at the same time.
Blinking
Frequency
(Every 4 sec)
Fault Cause
Solution
1
The battery is not connected or the
battery voltage is too low
1) Check battery connection is correct.
2) Check charger connection is correct.
Check each battery is good.
2
Abnormal AC Power Input (Voltage)
1) Check AC input cord is connected between charger and AC
outlet.
2) Make sure AC plug is tightly inserted into AC outlet.
3
Charger High Temperature Protection
1) Charger shuts down and enters protection mode due to
charger/environmental temperature is too high. Please place
the charger in a well-ventilated environment.
2) Disconnect the charger and wait for 15-20mins before
reconnecting.
4
Battery High Temperature Protection
1) Charger will reduce output current and stop charging when
the battery temperature exceeds 50°.
2) Disconnect the charger and wait for 15-20 mins before
reconnecting for charging.
5
Output Current is too large
Return to the factory for repair.
6
Battery voltage is too high
Check and assure that the correct output battery voltage is
connected.
Page12
Enerdrive ePOWER Industrial Battery Charger Owner’s Manual (Rev. 1.4)
Summary of Contents for ePower Industrial EPI-2430
Page 1: ...Operation Owner s Manual 24V 36V 48V Models Rev 1 4...
Page 2: ......
