16
www.enelx.com
Phone: +1-844-584-2329
Installation
3. Place front panel on ground
The front panel is attached to the
enclosure with wiring and an earthing
strap on the front left hand side.
Lift the front panel up to release from the
top hook and gently lower to the ground
in front of the JuicePump.
In calm conditions it may be possible to
keep the front panel connected during
commissioning. If this is possible, go to
page 17, item 5.
If in doubt, disconnect the front panel
(see pg 17, item 4) and store in a safe
place until the unit is ready to close for
use.
1. Secure to foundation
Lift the JuicePump by the supplied lifting
straps, place onto the prepared
foundation and secure with the specified
fasteners.
Note: Use the plastic inserts you kept
earlier in the baseplate holes.
2. Remove fasteners from front panel
Remove the 6x security screws and
washers from the front panel using the
provided 5mm pin hex tool.
