EndRun Sonoma D12, User Manual

Page: 89 / 172

S o n o m a U s e r M a n u a l 72
C H A P T E R N I N E
73 S o n o m a U s e r M a n u a l
C O N T R O L A N D S T A T U S C O M M A N D S
Detailed Command
Descriptions
accessconfig
This command starts an interactive script that will allow the root user to configure access limitation
via
telnet
,
ssh
and
snmp
to the Sonoma. By default, the unit is configured to allow access by all
users. If you need to limit
telnet
,
ssh
or
snmp
access, e.g. for security reasons, you must run this
script as root from either the RS-232 serial I/O port or from a
telnet
or
ssh
session.
This script modifies these files: /etc/hosts.allow and /etc/hosts.deny . These are non-volatilely stored
in the FLASH disk
/boot/etc
directory. You must reboot the Sonoma after running this script for the
changes to take effect.
Command:
accessconfig
Sonoma reply: Interactive script is started.
caldelay
This command displays the current calibration delay setting. The allowable calibration delay range is
±500,000 nanoseconds.
Command:
caldelay
Sonoma reply:
+0 nanoseconds
cdmachannelset
This command displays the CDMA channelset currently being used by the CDMA Subsystem. It can
be one of: North American Cellular, South Korean Cellular, North American PCS, Indian Cellular or
for certain units, Japanese Cellular.
Command:
cdmachannelset
Sonoma reply:
Channelset is North American PCS
cdmaleapconfig
Leap seconds affect NTP, UTC and Local Time (not GPS Time). Leap second insertions occur about
once every two-three years. This command starts an interactive shell script that will guide you (as
root user) in configuring the leap seconds.
You will need to execute this command when a leap second is pending. The interactive script is very
detailed in explaining how these values are obtained and used. There is also more information in
Ap-
pendix F - Leap Seconds .
Command:
cdmaleapconfig
Sonoma reply: Interactive shell script is started.