Proline Promag 55 FOUNDATION Fieldbus
Operation
Hauser
57
5.3.1
General notes
The Quick Setup menu is adequate for commissioning with the necessary standard settings.
Complex measuring operations on the other hand necessitate additional functions that you can
configure as necessary and customize to suit your process parameters. The function matrix,
therefore, comprises a multiplicity of additional functions which, for the sake of clarity, are arranged
on a number of menu levels (blocks, groups, and function groups).
Comply with the following instructions when configuring functions:
• You select functions as described
Each cell in the function matrix is identified by a numerical or letter code on the display.
• You can switch off certain functions (OFF). If you do so, related functions in other function groups
will no longer be displayed.
• Certain functions prompt you to confirm your data entries. Press
O
/
S
to select "SURE [ YES ]"
and press
F
again to confirm. This saves your setting or starts a function, as applicable.
• Return to the HOME position is automatic if no key is pressed for 5 minutes.
• Programming mode is automatically disabled if you do not press a key within 60 seconds
following automatic return to the HOME position.
"
Caution!
All functions are described in detail, including the function matrix itself, in the "Description of
Device Functions" manual, which is a separate part of these Operating Instructions.
!
Note!
• The transmitter continues to measure while data entry is in progress, i.e. the current measured
values are output via the signal outputs in the normal way.
• If the power supply fails, all preset and parameterized values remain safely stored in the EEPROM.
5.3.2
Enabling the programming mode
The function matrix can be disabled. Disabling the function matrix rules out the possibility of
inadvertent changes to device functions, numerical values or factory settings. A numerical code
(factory setting = 55) has to be entered before settings can be changed.
If you use a code number of your choice, you exclude the possibility of unauthorized persons
accessing data (
→
"Description of Device Functions" manual).
Comply with the following instructions when entering codes:
• If programming is disabled and the
O
/
S
keys are pressed in any function, a prompt for the code
automatically appears on the display.
• If "0" is entered as the customer’s code, programming is always enabled.
• The Hauser service organization can be of assistance if you mislay your personal code.
"
Caution!
• Changing certain parameters such as all sensor characteristics, for example, influences numerous
functions of the entire measuring system, particularly measuring accuracy. There is no need to
change these parameters under normal circumstances and consequently, they are protected by a
special code known only to the Hauser service organization. Please contact
Hauser first if you have any questions.
• With FF, programming is enabled separately in the Transducer Blocks.
5.3.3
Disabling the programming mode
Programming mode is disabled if you do not press a key within 60 seconds following automatic
return to the HOME position.
You can also disable programming in the ACCESS CODE function by entering any number (other
than the customer's code).
