background image

Safety instructions

Oxymax H COS21

2

Hauser

1

Safety instructions

1.1

Designated use

The sensor is suitable for continuous measurement of dissolved oxygen in water.

Major applications:

• Process control in enzyme production
• Control of culture growth
• Biotechnological production
• Food industry
• General process applications

Any other use than the one described here compromises the safety of persons and the entire 
measuring system and is, therefore, not permitted.
The manufacturer is not liable for damage caused by improper or non-designated use.

1.2

Installation, commissioning and operation

Please note the following items:
• Installation, commissioning, operation and maintenance of the measuring system must only 

be carried out by trained technical personnel. 
The technical personnel must be authorized for the specified activities by the system operator.

• Electrical connection must only be carried out by a certified electrician.
• Technical personnel must have read and understood these Operating Instructions and must 

adhere to them.

• Before commissioning the entire measuring point, check all the connections for 

correctness. Ensure that electrical cables and hose connections are not damaged.

• Do not operate damaged products and secure them against unintentional 

commissioning. Mark the damaged product as being defective.

• Measuring point faults may only be rectified by authorized and specially trained 

personnel.

• If faults can not be rectified, the products must be taken out of service and secured against 

unintentional commissioning.

• Repairs not described in these Operating Instructions may only be carried out at the 

manufacturer’s or by the service organisation.

1.3

Operational safety

The sensor has been designed and tested according to the state of the art and left the factory in 
perfect functioning order.
Relevant regulations and European standards have been met.

As the user, you are responsible for complying with the following safety conditions: 
• Installation instructions
• Local prevailing standards and regulations.

Summary of Contents for Oxymax H COS21













Reviews: