Endress+Hauser Cerabar S PMC71, Functional Safety Manual

Page: 37 / 48

Cerabar S PMP71 Appendix
Hauser 37
8.2.1 Pressure device parameter configuration form
Operation via:  Handheld terminal  FieldCare/DeviceCare  On site
Device designation: Serial number:
Measuring
point: Upper range limit (URL sensor):
Parameter name Direct
access Menu path:
Expert Factory setting
1)
Permitted
settings Set
point Actual
value Tested
Digit set 840 → Display 012345
67890.-
Calib. offset 319 → Position
adjustment 0.0
2)
Measuring mode 389 Pressure Pressure
Set LRV 245 → Quick Setup /
Basic Setup 0.0 or as per order
2)
Set URV 246 URL sensor or as per order
2)
Damping value 247 2 s 0 to 999 s
Press. eng. unit 060 → Basic setup mbar/bar
or as per order
3)
All
except "user unit"
Current charact. 695 → Output Linear Linear
Output fail mode 388 Max. alarm Max. alarm
Min. alarm
Alt. curr. output 597 Normal Normal
Set max. alarm 342 22 mA 21 to 23 mA
Set min. current 343 3.8 mA 3.8 mA or 4 mA
Simulation 413 → Simulation None None
Ack. alarm mode 401 → Messages Off Off/On
Error No. Select alarm
type
The following messages
must be set to "Alarm": 595/600
115 Sensor over pressure Warning Alarm o. warning
120 Sensor low pressure Warning Alarm o. warning
715 Sensor over
temperature Warning Alarm o. warning
717 Transmitter over
temp. Warning Alarm o. warning
718 Transmitter under
temp. Warning Alarm o. warning
720 Sensor under
temperature Warning Alarm o. warning
726 Sens. temp. error
overrange Warning/alarm
4)
Alarm
727 Sens. pres. error
overrange
5)
Warning Alarm o. warning
620 Current output out
of range Warning Alarm o. warning
Alarm delay 336 0.0 s 0.0 s
Alarm display time 480 0.0 s 0.0 s