Tool Hose Balancer Users Manual
26
CAUTION
Be sure to use the product within the capacity range.
NOTICE
Adjust the spring tension before the operation.
Remove the tool (equipment) while lifting it and with the hose completely wound inside the drum.
1
Shut off the air supply and release the hose pressure.
2
Remove the tool (equipment) while lifting it and with the hose completely wound inside the drum.
3
Install the tool (equipment) and adjust the spring tension in accordance with “5-2-2 Installation of
tools and equipment and adjustment of the spring tension”.
6-4 Periodical inspections
Perform an inspection at least once per month.
If the product is used in an unfavorable environment or used frequently, reduce the interval between
the inspections.
Inspection of the hook
See the figure on the right, measure the relevant
dimensions of the hook, and check the measured
dimensions against the operating limits.
The hook must be replaced when any dimensions have
reached the limiting dimensions.
Stop using the balancer, and contact us or your dealer.
7.
Troubleshooting
7-1 Countermeasures
WARNING
Do not remove the tool (equipment) attached to the hose end until the cause of the
failure is identified. If the tool (equipment) is removed, the hose may be quickly
wound up, causing an injury.
CAUTION
If you notice anything unusual, stop the operation immediately. After checking the
items listed in the table below, appropriate measures should be taken by a
maintenance operator who has developed sufficient knowledge and operating skill
for the balancer.
If the situation does not relate to any of the listed items in the table below, contact
us or your dealer.
Operating limit of the hook
Copied
digital
data
from http://www.endo-kogyo.co.jp/
