Tool Hose Balancer Users Manual
24
5-3 Post-installation checks
5-3-1 Checking the working range (stroke)
1
Ensure that work can be performed within the range of the stroke.
For the stroke of each product, see “4-2-1 Specifications”.
2
If the range of the stroke is insufficient, lower the
installation height of the balancer or use an extension
hose.
6.
Usage
6-1 Pre-operation inspections and checks
WARNING
If any abnormality is found as a result of inspection, do not use the balancer.
If any loose bolts or screws are found in the inspections, retighten the bolts and
screws.
When you notice any wear, deterioration or deformation of the parts, contact us or
your dealer.
Inspect and check the following items before starting the operation:
Check of the surroundings
1
Ensure that there is no trash or unnecessary equipment around the balancer or in the work
space.
2
If there is any obstacle and the like that cannot be removed, contact the person in charge of the
work.
Inspection of the support member (metal hanger)
1
Check that the support member (metal hanger) is not
worn.
2
If any wear is found, immediately stop the operation.
NOTICE
Do not pull out the hose too much.
Doing so may damage the balancer.
Stroke
Note: The auxiliary wire rope, the
support member, and the tool
(equipment) in the figure are
indicated for reference.
Wear
Note: The support
member (metal
hanger) in the
figure is indicated
for reference.
Copied
digital
data
from http://www.endo-kogyo.co.jp/
