- 25 -
5) Insert a screw driver into the space between the band and the spring as shown in Figure 26 (page
22), then remove the band.
Take care not t o cat c h your f i nger i n t he s pri ng si nce t h e spri n g w i ll expa nd
expl osi vel y w hen t he band i s rem o ved.
6) Lubricate the spring with 22 cm
3
(mL) of grease (KYODO, ONELUBER MP No.2 or
equivalents).
Spread grease all over the spring.
(8) Attach the bush with the non-circular hole to the spring with the spring case.
The machined end of the bush should face upward.
(9) Stand the drum with the spindle being horizontal.
Secure the drum by some means not to allow falling or moving.
(10) Place the notch key and notch springs into the slot of the spindle.
Take care as the assembling direction of the notch key depends on the winding direction of the reel.
Refer to Figure 23 (page 21).
(11) Keep the notch key in the slot using the installed bush.
While pressing the attached notch key in the slot with a finger, grip the spring near the bush by pliers
and slowly pull about 30 mm, then release.
The spring will move back for some length which varies depending on the spring type.
Check the notch key does not protrude from the spindle surface.
If protruding, pull the spring near the peripheral
portion about 10 mm, then pull the spring near
the bush about 10 mm.
Try until the notch key does not protrude from
the spindle surface.
Refer to Figure 30.
Never p ul l t he spri n g t oo m uch o r roug hl y.
O t herw i se, t he spri ng w il l burst out an d ca use person al i nj ury.
(12) Lightly lubricate the bush attaching portion of the spindle and the inside surface of the bush with
grease (IDEMITSU, DAPHNE EPONEX GREASE SR No.1 or equivalents).
Install the spring with the spring case to the spindle by holding the spring case with one hand and
holding the bush with another hand.
Take care not t o al l o w t he spri ng cent er t o f al l and burst o ut .
(13) Lay the drum again on a work table.
Rotate the spring case back and forth until the spring case fits into the bush.
(14) Lubricate the spring with 22 cm
3
(mL) of grease (KYODO, ONELUBER MP No.2 or equivalents).
Spread grease all over the spring.
(15) Follow the procedure given in Section 13-3. "Common reassembly method" (page 27).
Ｐｕｌｌ ｈｅｒ
ｉｆ ｎｅｃｅｓｓａｒｙ．
Ｄｒｕｍ
Ｐｌｉｅｒｓ
Ｓｐｒｉｎｇ
Ｎｏｔｃｈ ｋｅｙ
Ｎｏｔｃｈ ｓｐｒｉｎｇ
Ｎｏ ｐｒｏｔｒｕｓｉｏｎ．
Figure 30
Copied
digital
data
from
http://www.endo-kogyo.co.jp/
