Frame Relay Configuration 6-13
Network Protocols and Bindings
The following sections outline the steps necessary to configure the Network
Protocols and Bindings so the interfaces can be used with the LAN and
WAN connections just established.
Configuration of protocols and bindings must be completed prior to using the
Emulex software.
Configuring Protocol Parameters
1)
From the Internetworking Configuration menu, select
Protocols
and
press <Enter>.
Figure 6-8 Internetworking Configuration
2)
The Protocol Configuration menu is displayed.
Figure 6-9 Protocol Configuration
3)
From the
Protocol Configuration
menu, select all desired protocols
needed for support over the WAN link. Each protocol presents a unique
menu for its configuration. You should accept the default settings.
Summary of Contents for DCP_link
