4-2 Chapter 4
Software Installation Procedure
This section describes the installation procedure for the Emulex DCP_
link
software. The software can be installed either locally on a single server or
remotely on several servers.
If NetWare MPR 3.0 software has been successfully loaded on your system,
please continue with installation of the Emulex software. The installation
procedure has been divided into two subsections based upon the version of
Novell NetWare you are using (version 3.12 or 4.1):
Installing to Novell NetWare version 3.12
1)
At the NetWare server system console prompt, type
>
Load Install <Enter>
The Installation Options menu appears.
Figure 4-1 The Installation Options Menu
2)
Select
Product Options
and press <Enter>.
A list of currently installed products (if any) is displayed.
3)
Press <Ins> to begin the installation.
4)
Insert the DCP_
link
INSTALL diskette into a floppy disk drive and enter
the drive’s letter; simply press <Enter> to accept the default drive A:
Figure 4-2 Install Drive Path
Summary of Contents for DCP_link
