Software Installation 4-5
Note: If you inserted the INSTALL diskette into drive B: on a
local server, press <F3>, replace A:\ with B:\, then
press <Enter>.
After a short delay, the Installation Options menu appears.
Figure 4-6 The Installation Options Menu
3)
Install on Local Server Only
is highlighted; press <Enter>.
The INSTALL program copies several files from the INSTALL diskette
to a local directory.
4)
When the source files have been copied, the following message is
displayed:
Installation was successful. Bring down and restart each
server on which you installed the software to ensure that it
uses the newest NLM files.
<Press ENTER to continue>
5)
Press <Enter>, the Installation Options menu will again be displayed.
6)
Select
Display Log File
to check for any installation problems. A list of
any files that were not installed (for any reason) is displayed at the
bottom of the file.
7)
Select
Display README Files
for new additions or information.
8)
Select <Exit> to continue the installation. The list of Currently Installed
Products is displayed
.
Verify that
EMULEX WAN for NetWare
has
been added to the list.
Summary of Contents for DCP_link
