2-6 Chapter 2
DCPx86i/e Adapter Configuration
The remainder of Chapter 2 is divided into three sections according to
adapter type (DCP286
i
-SBC, DCP386
i
, or DCP486
e
). Please refer to the
section for the adapter you are installing.
DCP286i-SBC Adapter Configuration
The following diagram of the DCP286
i
-SBC adapter shows the location of
all option setting switches and jumpers:
Figure 2-4 DCP286i-SBC Jumper Block Placement
Jumper Settings
NOTE: Jumper block J13 sets the Host Interrupt Level and
SW1 sets the base I/O address for the 286 adapter.
Reference the beginning of this chapter for details
on these settings.
Summary of Contents for DCP_link
