Page 40
Series 2000/3000 IDU User’s Manual
Revision P4
REBOOT (<boot_type> : <num>)
Where <boot_type> indicates if it was a
soft reset or a power up and <num> refers
to the number of soft resets since last
power up.
SIT Operational State: IDLE
This information is also displayed on the IDU
Monitoring page
SIT Operational State: INITIALIZED
SIT Operational State: HOLD
SIT Operational State: OAM ACTIVE
SIT Operational State: ACTIVE
SIT Operational State: FAULT
Transmission State: Enabled
This information is also displayed in the IDU
Monitoring page
Transmission State: Disabled
SYNC: PCR Received
Only shows up after an error “PCR Miss-
ing.” occurs.
SYNC: PCR No Longer Being Reloaded
Only shows up after an error “PCR
reload.” occurs.
SYNC: Start of Frame Timing is OK
Only shows up after an error “SOF time-
out.” occurs.
H/W: PLL Locked
Only shows up after an error “PLL Lock
Lost.” occurs.
H/W: 10 MHz Reference Received
Only shows up after an error “10 MHz
Reference NOT Received.” occurs.
Action Triggered via WEB Page: <action
detail>
Where <action detail> is a web interface
triggered action (from installer, superuser,
and satnetwork users).
SNMP: SET Received => <object name>
Where <object name> is a settable MIB
object name.
SNMP: Trap Sent => <trap object name>
Where <trap object name> is a trap that
can be generated by the terminal.
Message Received from hub: <message
detail>
Where <message detail> is a message
received from the hub.
RADIUS: User Authentication STARTED
(<username>)
RADIUS: User Authentication SUCCEEDED
(<username>)
Table 14:
