Page 7
Series 2000/3000 IDU User’s Manual
Revision P4
Figure 1.8 Back View - Series 3000 IDU
The shaded areas are as follows (from left to right).
• Connect to DC power transformer supplied with the IDU. Requires C8 type power
cord, not supplied with the IDU (AC Inlet Connector IEC-60320-1-C8). 110-220
VAC, 50/60 Hz (auto-ranging).
• IDU IN connector. F-Female 75 ohm connector for IFL cable from ODU. For forward
link communication.
• Ethernet connector. 10/100BaseT Ethernet Interface on RJ-45 connector. For ethernet
connection with LAN or host computer.
• Reset. The Reset button resets the IDUs ethernet IP address to its default value of
10.10.10.10. The IP address remains at this value until the unit is rebooted. To push
the reset button, insert a paper clip (or equivalent) into the hole for about one second.
IDU OUT connector. F-Female 75 ohm connector for IFL cable from the ODU. For return
link communication.
1.5
Overview of the IDU Web Interface
The IDU web interface provides the user interface with the IDU. The IDU web interface
can be accessed from any computer with a network or Internet connection to the IDU. The
IDU web interface enables you to:
• Set installation parameters
• Configure the SIT to access the satellite network
• Test and troubleshoot satellite links
• Configure passwords and security settings on the SIT
• Monitor SIT alarms and events
• Manage how the SIT queues and transfers data over the satellite network.
Note: For initial access to the IDU’s web interface from a local computer
or over the air, refer to the IDU Installation Manual,
1.5.1 IDU Web Interface Page
The figure below shows a typical IDU web interface page. All IDU web pages display the
following information.