![background image](http://html1.mh-extra.com/html/empire-comfort-systems/white-mountain-hearth-dvtl27fp90n/white-mountain-hearth-dvtl27fp90n_installation-instructions-and-owners-manual_2404026044.webp)
33740-17-0120
Page 44
MUltiFUnction reMote operatinG instrUctions
initializing the system for the First time
1. Remove the wall cover. Remove cover on the wall mounted
battery back-up holder.
see Figure 57
. Install the four AA
batteries into the wall mounted battery back-up holder then
reinstall the cover.
see Figure 58.
2. Install three AAA batteries into the battery bay located on the
base of the transmitter.
see Figure 59.
3. Set the wall remote slide switch to the “REMOTE” position.
see Figure 58.
4. Press and release the SWI button on the wall control with
a paper clip and the IFC module will beep three times to
indicate the IFC module is ready to synchronize with the
transmitter within ten seconds.
see Figure 58.
Figure 57
SWI
BUTTON
Figure 58
5. With the batteries already installed in the Transmitter, push
the On button. The Receiver will “beep” four times to indicate
the Transmitter’s command is accepted and sets to the par-
ticular code of that Transmitter. The system is now initialized.
Figure 59
temperature indication Display °c or °F
With the system in the “OFF” position, press the Thermostat
Button and the Mode Button at the same time. Look at the LCD
screen on the Transmitter to verify that a °C or °F is visible to the
right of the Room Temperature display.
see Figures 60 and 61.
Figure 60
Figure 61