26563-0-0410
Page 12
CAUTION: During the initial purging and subsequent lightings,
never allow the gas valve control knob to remain depressed in
the "pilot" position without pushing the piezo ignitor button
at least once every second.
2. D u r i n g t h e
heating season,
l e a v e t h e
control valve
knob in the
"ON" position.
This will allow
the pilot flame
to remain lit.
Turn the burner
flame on or off
with the appliance REMOTE/OFF/ON rocker switch, wall
switch, remote control kits or 750 millivolt wall thermostat.
NOTE:
The gas control valve allows you to increase or decrease the
height of the main burner flame. The control valve has a pressure
regulator with a knob as shown in Figure 10 . Rotate the knob
clockwise to "HI" to increase the flame height and counterclockwise
to "LO" to decrease the flame height.
3. When the heating season is over, turn the REMOTE/OFF/ON
switch to "OFF" and the control valve to "OFF". The system,
including the pilot light, will be shut down.
Maximum and Minimum Input
The gas valve on the appliance allows the input to adjust between
a maximum input of 32,000 Btuh to a minimum input of 22,400
Btuh. Please be advised, the maximum input provides the greatest
amount of yellow flame and ember glow on the log set. The minimum
input substantially decreases the yellow flame and ember glow on
the log set.
Before operating this heater, please review the safety warnings
pages at the beginning of this manual and those precautions and
warnings listed below.
1. Know what type of ignition system this model has (standing
pilot) and follow the applicable SAFETY and LIGHTING
instructions.
2. Check to ensure there are no gas leaks. If you are unsure, turn gas
off to the heater and call a service person or your gas utility.
CAUTION:
Clothing or other flammable material should not
be placed on or near the appliance.
WARNING: Children and adults should be alerted to the
hazard of high surface temperature and should stay away
to avoid burns or clothing ignition. young children should
be carefully supervised when they are in the same room as
the appliance.
3. Tampering is DANGEROUS and voids all warranties. Any
component that is found to be faulty, must be replaced with an
approved component.
Initial Lighting (Figure 10)
Upon completing the gas line or turning the gas valve "ON" after it
has been in the "OFF" position, a small amount of air will be in the
lines. When first lighting the appliance, it will take a few minutes
for the lines to purge themselves of this air. Once the purging is
complete, the appliance will light and operate satisfactorily.
Subsequent lightings of the appliance will not require such purging
if the gas valve is not turned to "OFF."
Standing Pilot Operation
1. Follow the SAFETY and LIGHTING INSTRUCTIONS for
standing pilot controls found in this manual and on labels found
attached to the appliance.
Figure 10
OPERATING GUIDELINES
