![background image](http://html1.mh-extra.com/html/empire-comfort-systems/traditional-dxt30in-nat/traditional-dxt30in-nat_installation-instructions-and-owners-manual_2403983038.webp)
31210-1-0713
Page 38
INSERT MAINTENANCE AND SERVICE
Although the frequency of servicing and maintenance will depend
on use and the type of installation, you should have a qualified
service technician perform an appliance checkup at the beginning
of each heating season. Specific guidelines regarding each
appliance maintenance task are listed below.
IMPORTANT: TURN OFF THE GAS BEFORE SERVICING
YOUR APPLIANCE.
Cleaning Burner and Controls
Frequency:
Once annually.
By:
Qualified service technician.
Task:
Brush or vacuum the control compartment, DXT logs and
burner areas surrounding the logs.
Checking Flame patterns, Flame height
Frequency:
Periodically.
By:
Qualified service technician/Home owner.
Task:
Make a visual check of your fireplace’s flame patterns.
Make sure the flames are steady - not lifting or floating. The flame
sensor tips should be covered with flame.
Correct Flame pattern
Notice:
natural Gas flames maybe be taller than the ones
shown in the above graphic.
Checking Vent System
Frequency:
Before initial use and at least annually thereafter,
more frequently if possible.
By:
Qualified service technician/Home owner.
Task:
Inspect the external vent cap on a regular basis to ensure
that no debris is interfering with the flow of air. Inspect entire vent
system for proper function.
Cleaning Logs (DXT)
Use a soft brush attachment on a vacuum cleaner to gently remove
dust or soot deposits from logs and burner.
Glass Cleaning
It will be necessary to clean the glass periodically. During start-up
condensation, which is normal, forms on the inside of the glass and
causes lint, dust and other airborne particles to cling to the glass
surface. Also initial paint curing may deposit a slight film on the
glass. It is therefore recommended that the glass be cleaned two or
three times with a non-abrasive household cleaner and warm water
(we recommend gas fireplace glass cleaner). After that the glass
should be cleaned two or three times during each heating season
depending on the circumstances present.
General Glass Information
WARNING
Do not operate appliance with the glass front removed,
cracked or broken. Replacement of the glass should be done
by a licensed or qualified service person.
Only glass approved for use by the manufacturer in fireplace may
be used for replacement. The glass replacement should be done
by a licensed or qualified service person.
WARNING
1. The use of substitute glass will void all product warranties.
2. Care must be taken to avoid breakage of the glass.
3. Under no circumstances should this appliance be operated
without the glass front or with a broken glass front. Replacement
of the glass (with gasket) as supplied by the manufacturer
should be done by a qualified service person.
4. Do not abuse the glass by striking or hitting the glass.
WARNING
Do not use abrasive cleaners on glass. Do not attempt to
clean glass when glass is hot.