31210-1-0713
Page 15
GLASS ASSEMBLY REMOVAL
1. Remove the air deflector as shown in Figure 12.
Remove the air deflector from the outer firebox by removing
the two #8 x 1/2” Phillips truss head screws. See Figure 12.
Figure 12
2. Secure the glass assembly in place with one hand.
3. Insert the Latch Tool into the firebox at the top and hook it
onto the right glass clip.
4. Using steady force, pull the latch out and up until it disen-
gages from the glass assembly.
5. Repeat steps 1 through 3 for the left glass clip.
CAUTION
Top glass clips are tightly sprung. If the Latch tool slips off of
the clip while pulling, injury may occur. Ensure that the latch
tool is completely hooked around the glass clips before trying
to disengage the glass clips from the glass assembly.
NOTICE:
Latch tool must be stored near unit.
Figure 13
6. Angle the glass towards you from the top and firmly pull out.
CAUTION
Bottom glass clips do not require use of the latch tool to disen
-
gage them from the glass assembly. However, they are tightly
sprung and some force is needed to disengage them from the
glass assembly.
Figure 14